Independent left and right detection with BX Shield
The BX Shield outdoor sensors are designed to protect the immediate boundary of your premises against intrusion. Not affected by small animals or by environmental changes, they are a perfect trigger for alarm systems or outdoor CCTV cameras. They provide two independent left-right curtain detection areas up to 12m each (24m in total). The BX Shield are available as wired, wireless, and anti-masking models.
Filters
Filters
12m per side detection, hardwired outdoor PIR motion sensor, standard bi-colour model.
12m per side detection, outdoor PIR motion sensor, wireless bi-colour model with anti-masking.
12m per side curtain detection, outdoor PIR sensor. Hardwired bi-colour model with anti-masking
12m per side detection, outdoor PIR motion sensor, standard wireless model.
12m per side detection, outdoor PIR motion sensor, standard hardwired model.
12m per side detection, outdoor PIR motion sensor, wireless model
No, BX-80NR does not include a communication transmitter even though it is compatible with most of the brands. BX-80NR has a rear compartment where to hold a wireless transmitter.
No, unless the unit is installed on a flat surface.
The BX80NR is a wireless device which is powered by 3-9V CC batteries.
Yes, it can be adjusted by modifying each lens’ position.
The installation height is 0.80m to 1.2 m. This is applicable to all of the BX series units. In order to get the best result, install the detector from 0.09 to 1m high.
Yes, you can do it. The box contains masking tapes. Consult the installation manual for more details.
Adding our outdoor PIRs onto a wireless intrusion alarm system is simple. Our battery-operated sensors have enough space to accommodate most universal transmitters. As our sensors are very low current, the transmitter and sensor can be powered by the same batteries. A video was created to show you how to install the wireless transmitter. Watch our video tutorial.
Power up the sensor as normal and close the cover. When the cover is on, an automatic walk-test function is enabled. After 3 minutes, the sensor will flash quickly for 5 seconds to indicate that the walk test is going to expire.