26 November 2021 - Tom Opio
Featured in: Product information and OPTEX tech tips, Tech Tip, Intrusion detection
The SIP-AT is the necessary tool kit to ensure the correct detection set up for our Redwall SIP outdoor PIRs. The kit includes the Area View Finder AVF-1, the Audio Walk Tester AWT-3 and a set of area plates.
SIP Models requiring SIP tool kit accessory to be installed correctly
All REDWALL SIP models require the SIP-AT kit to be installed
Medium Range
- REDWALL SIP-3020 and 3020/5 & SIP-3020-and 3020/5-IP-BOX: 30x20m coverage
- REDWALL SIP-4010 and 4010/5 & SIP-4010- and 4010/5-IP-BOX: 40x10m coverage
- REDWALL SIP-404 and 404/5 & SIP-404- and 404/5-IP-BOX: 40x4m coverage
Long Range
- REDWALL SIP-100 & SIP-100-IP-BOX: 100x3m coverage
- REDWALL SIP-5030 & SIP-5030-IP-BOX: 50x30m coverage
Using Audio Walk Tester AWT-3 to confirm the coverage area
After the Redwall Outdoor PIR series device is installed and the mounting angle adjusted using the Area View Finder tool, the detection area needs to be tested to confirm the coverage is correct. To this purpose, the Audio Walk Tester AWT-3 should be used, and when walking in the detection area an audible tone will be heard from the tester confirming detection of the walker.
How to use the AWT-3
First, connect the Audio Walk Tester AWT-3 to the Redwall SIP sensor in its final installation location ready to perform a walk test. Set the sensitivity to super high and have a person walk zig zag in the detection area. A changing audible tone indicates the Redwall SIP outdoor PIRs series has detected the walk test person. A constant tone indicates no detection.
Testing each zone
The Audio Walk Tester AWT-3 has a dial to select each zone separately, check the zones supported by the model of Redwall Outdoor PIR series installed. Select one zone, perform a walk test then proceed to test the next zone till all zones are tested including creep zone if the model features one. Perform fine adjustments to ensure each zone coverage is correct in the walk test.
After the test, please set the dip switches to desired setting and complete the commissioning of the installed Redwall SIP outdoor PIRs series device.
You can watch the full SIP-commissioning tutorial on our Youtube channel