Optex cmod installation featured image

Tech tip: Installing the CMOD camera module to the VXI sensor

31 May 2022 - Tom Opio

Our best-selling VXI sensor can be upgraded with a CMOD camera module that fits seamlessly at the top of the detector to create a complete security solution that combines reliable detection with instant video verification. The installation of the CMOD to the VXI sensor can be done in a few...

Read more
Backround Laser Graphic V2

Tech tip: Aligning the OPTEX SL beams

4 May 2022 - Tom Opio

Infrared beams offer an excellent perimeter protection solution by sending a continuous signal from a transmitter to a receiver and it is essential that the signal from the transmitter aligns perfectly with the receiver, and here is how the alignment and walk test should be done for the SL-series

Read more
Optex tech tip rls 2020 maintenance blog card

Tech tip: Maintaining the REDSCAN RLS-2020 lens

5 April 2022 - Tom Opio

The RLS-2020 is a compact LiDAR sensor used for many precise indoor and outdoor detection applications. To keep a consistent level of detection performance, it is critical to maintain the sensor’s lens in good condition, and here’s how to do it.

Read more
Optex tech tip walk test blog card

Tech tip: How to walk test the WXS and BXS sensors

28 February 2022 - Tom Opio

The BXS (curtain) and WXS (180-degree) sensors offer independent left and right detection areas and precise detection zones on each side can be set to adapt to the property’s features and areas where coverage is needed. Performing a walk test is a crucial step to validate the detection areas set...

Read more